Tlakové spínače mechanické
Tlakové spínače průtokové
Invertory
PříslušenstvíPRESSURE AND FLOW CONTROLLERS BRIO TANK
Electronic device for electric pump control
- It automatizes the start and stop operations of single-phase electric pumps up to 2HP
- It replaces completely the traditional water system set up consisting on pressure switch and pressure tank
- It starts the electric pump after a pressure decrease (taps opening) and stops it when the fluid flow interrupts at the maximum pressure level of the electric pump (taps closing)
- Automatic reset up to 10 attempts
- 24 hour anti-block protection
- A small 0,4 l water tank is integrated and itprevents unlikely frequent start and stop of the pump in case of small request of water and in case of leakages on the installation
- Replaceable butyl membrane of the pressure tank
- Adjustable pre-charge pressure (factory setting 1,5 bar) of the pressure tank
- Integrated pressure gauge
- It protects against the dry running and water hammering
- Starting pressure is adjustable during installation
- Standard 1" M hydraulic connections
- Installation in any position - both vertical and horizontal - according to the flow direction
- Electronic printed circuit board housed in a waterproof compartment protecting against water condensation
- No need of maintenance
| Powe supply: | 230Vac +-15% 50/60Hz |
| Max rated current: | 12 A (2Hp) 1500W |
| Starting pressure range: | 1÷ 3,5 bar (1,5 standard) |
| Max allowable pressure: | 10 bar |
| Gross volume of pressure tank: | 0,4l |
| Fluid temperature: | 5°C - 35°C |
| Ambient temperature: | 5°C - 45°C |
| Hydraulic connections: | 1"M |
| Protection degree: | IP 65 |
